next »

[CPRstreetmachines]

66 mustang coupe with a versi 9".

Parts list: lokar staineless e-brake cables, lokar chrome handle and clevis.

rear disc brake set up with no e-brake line  brackets which is fine because they wouldn't of worked anyway...


made a braket out of 1/8" steel and attached to the existing 9" spring perch braket


routing the lines for the ebrake in the stock locations up to the center lever

[CPRstreetmachines]

next is the mounting point for the lever.

[CPRstreetmachines]

one that should be done when installing a center pull e brake lever is to reinforce the floor where you will cutting the hole.

Here we show the plate and where it will be welded to the center trans hump for reinforcement.


this is how the boot cover plate will attach to the newly installed reinforment plate.

[CPRstreetmachines]

cut the hole in the floor board and put the reinforcement plate on


plate welded to the floor


pictures of the cables routed in the stock location


rear picture of the cables


completed with clevis

[CPRstreetmachines]

almost done...